FREQUENCY: 47 to 63 Hz.
POWER FACTOR: > 0.99 @ Full Load.
HARMONIC CURRENT: < 5%.
OUTPUT
ADJUSTMENT RANGE: +5%/-10% of nominal
output voltage.
POLARITY: Output is isolated. It may be
referenced plus/minus as required.
REMOTE SENSING: Compensates for up to
0.5V total loop drop in the output line.
STATIC REGULATION:
Line: ±0.25% over full line range.
Load: ±0.25% zero load to full load.
VOLTAGE STABILITY: ±0.1% for 24-hour period
after 30-minute warm up.
TEMP COEFFICIENT: ±0.02%/°C from 0°C to
+50°C.
P-P RIPPLE AND NOISE:
1% (20 Hz to 50 MHz Bandwidth).
MINIMUM LOAD: Not Required.
TURN ON DELAY: 1 sec. max from application
of AC line.
OVERVOLTAGE PROTECTION: 125% ±5% of
nominal. OVP shutdown is latched until the input
line is removed for 5 secs and then reapplied.
OVP sensing is done at the output terminals.
OVERCURRENT PROTECTION: Current Limit
Point: 105% to 115% of full load.

频率：47至63赫兹。
功率因数：>0.99@满载。
小于5%的谐波电流：。
输出
调整范围：+5%/-10%标称值
输出电压。
极性：输出被隔离。可能是的
根据需要引用加号/减号。
遥感：补偿高达
输出线的总回路压降为0.5V。
静态调节：
线路：在整个线路范围内±0.25%。
负载：±0.25%零负载至满载。
电压稳定性：24小时内±0.1%
30分钟热身后。
温度系数：±0.02%/°C从0°C到
+50摄氏度。
P-P波纹和噪声：
1%（20 Hz至50 MHz带宽）。
小负载：不需要。
开启延迟：1秒。来自应用程序的max
交流线路。
过电压保护：125%±5%
名义上的OVP关闭被锁定，直到输入
移除管线5秒，然后重新涂抹。
OVP感应在输出端完成。
过电流保护：电流限制
点：满载的105%至115%。