联系人：麦女士
手机：+86 15270269218
电话：
Q Q：3136378118
邮箱：stodcdcs@gmail.com
地址：江西省九江市瑞昌市东益路23号赛湖农商城401号
如系统中既有并联模块又有多路复用模块，请在上表中选择多路复用控制器，
然后将电缆适配器与该控制器连接。
• 如所有模块为并联模式，请分别连接各个模块。以下模块可在并联模式下运
行：
2. 将电缆适配器后部的 50 针引脚母头插入 SCXI 模块后部的 50 针引脚公头中。
注意 请勿强行插入适配器。强行插入适配器可能折弯引脚。
3. 用 SCXI-1349 配备的螺丝将适配器固定在 SCXI 机箱背面。
If there are both parallel modules and multiplexing modules in the system, please select the multiplexing controller in the above table,
Then connect the cable adapter to the controller.
• if all modules are in parallel mode, please connect each module separately. The following modules can be operated in parallel mode
that 's ok:
2. Insert the 50 pin female connector at the rear of the cable adapter into the 50 pin male connector at the rear of the scxi module.
Be careful not to forcibly insert the adapter. Forcibly inserting the adapter may bend the pins.
3. Fix the adapter on the back of the scxi chassis with the screws equipped with scxi-1349.
