140CPS21100
可以将记录道设置为以下模式。
•写入模式第6.2节
•固定模式第6.2节
•大/小保持模式第6.3节
•滚动平均模式第6.4节
•计算模式第6.5节至第6.9节
下面解释了每种模式。
写入模式
波形数据在扫描期间写入。
当记录道设置为写入模式时，在测量过程中写入波形数据，
并更新数据。测量中使用的记录道通常设置为写入
模式数据区侧面的跟踪显示变为“写入”
修复模式
修复数据；不写入波形数据。
当记录道设置为固定模式时，即使在以下情况下，其波形数据也不会被覆盖
进行测量。因此，屏幕上的波形不会被覆盖。如果
要修复记录道的波形数据，请将记录道设置为修复模式。跟踪显示
在数据区域的一侧更改为“修复”

Traces can be set to the following modes. • WRITE mode Section 6.2 • FIX mode Section 6.2 • MAX/MIN HOLD mode Section 6.3 • ROLL AVG mode Section 6.4 • CALCULATE mode Section 6.5 to Section 6.9 The following explains each of the modes. WRITE Mode Waveform data are written during sweeping. When a trace is set to WRITE mode, waveform data are written during measurement, and the data are updated. Traces used in measurements are normally set to WRITE mode. The trace display at the side of the data area changes to “WRITE.” FIX Mode Fixes the data; does not write waveform data. When a trace is set to FIX mode, its waveform data are not overwritten even when measurement is performed. Therefore, the waveform on the screen is not overwritten. If you want to fix the waveform data of a trace, set the trace to FIX mode. The trace display at the side of the data area changes to “FIX.”