安装电缆适配器
多机箱系统
SCXI-1346 包含两个模块的后端连接器。位于与 SCXI-1346 连接的模块右侧的模块，其
后部的 50 针引脚接口不能连接外部电缆。
SCXI-1000 机箱至 D 版均没有地址跳线或连接任何地址的开关，不能用于多机箱系统。
E 版机箱采用 0 号插槽上的跳线作为机箱编址。 F 版及更高版本机箱采用 DIP 开关作为
机箱编址。
SCXI-1000DC 机箱至 C 版均没有地址跳线或连接任何地址的开关，不能用于多机箱系
统。 D 版机箱采用 0 号插槽上的跳线作为机箱编址。
SCXI-1001 至 D 版机箱采用 0 号插槽上的跳线作为机箱编址。 E 版及更高版本机箱采用
DIP 开关作为机箱编址。

Install the cable adapter
Multi chassis system
The scxi-1346 contains the back-end connectors of two modules. The module on the right side of the module connected to scxi-1346
The rear 50 pin connector cannot be connected to external cables.
Scxi-1000 chassis to version D do not have address jumper or switch connecting any address, so it cannot be used in multi chassis system.
Version e chassis uses the jumper on slot 0 as the chassis address. The chassis of version F and higher adopts dip switch as the main switch
Addressing chassis.
There is no address jumper or switch connecting any address from scxi-1000dc chassis to version C. It cannot be used in multi chassis system
Unification. Version D chassis uses the jumper on slot 0 as the chassis address.
The scxi-1001 to D chassis uses the jumper on slot 0 as the chassis address. The chassis of version E and higher adopts
Dip switch is used as chassis addressing.