MVME297-256
简介本章提供嵌入式控制器的开箱说明、硬件准备指南和安装说明。MVME712系列过渡模块的硬件准备在单独的手册中描述；请参阅1章中的相关文档部分。开箱说明注意：如果装运纸箱在收到后受损，请要求承运人代理人在开箱和检查设备时在场。将设备从装运箱中取出。参考装箱单，确认所有物品均已存在。保存包装材料，以便设备储存和重新装运。注意避免接触集成电路区域；静电放电会损坏电路。硬件准备为了生成所需的配置并确保的正确操作，您可能需要在安装模块之前进行某些修改。提供对大多数选项的软件控制：在系统中安装后，通过在控制寄存器中设置位，可以修改其配置。（寄存器在4章中有描述，和/或在1章相关文档中列出的嵌入式控制器程序员参考指南中有描述。）然而，有些选项不是软件可编程的。此类选项通过手动安装或拆除收割台跳线或接口模块进行控制。

Introduction This chapter provides unpacking instructions, hardware preparation guidelines, and installation instructions for the Embedded Controller. Hardware preparation for the MVME712 series transition modules is described in separate manuals; refer to the Related Documentation section in Chapter 1. Unpacking Instructions Note If the shipping carton is damaged upon receipt, request that the carrier’s agent be present during the unpacking and inspection of the equipment. Unpack the equipment from the shipping carton. Refer to the packing list and verify that all items are present. Save the packing material for storing and reshipping of equipment. Caution Avoid touching areas of integrated circuitry; static discharge can damage circuits. Hardware Preparation To produce the desired configuration and ensure proper operation of the , you may need to carry out certain modifications before installing the module. The provides software control over most options: by setting bits in control registers after installing the in a system, you can modify its configuration. (The registers are described in Chapter 4, and/or in the Embedded Controller Programmer’s Reference Guide as listed in Related Documentation in Chapter 1.) Some options, however, are not software-programmable. Such options are controlled by manual installation or removal of header jumpers or interface modules.