XVME-957
安装注意事项
本节介绍在将1600放入
圈占地
考虑以下要点和注意事项：

选择一个机柜并将设备放置在便于访问的位置
1600个端口。

选择外壳深度时，考虑装置的深度。
装置必须安装在经批准的防火和电气外壳中。

本节中的安装尺寸和说明见11页至15页
章

考虑AC电源插座等附件的安装位置，以及
维护方便。
通过安装恒温器控制的加热器或空气防止冷凝
护发素。

为实现大冷却，避免阻碍气流。

将所有风扇或鼓风机靠近发热设备。如果使用风扇，
确保外部空气不会进入外壳内部，除非使用织物或其他
使用可靠的过滤器。这种过滤可防止导电颗粒或其他
有害污染物进入外壳。

不要选择产生过多电磁波的设备附近的位置
干扰（EMI）或射频接口（RFI）（高
电力焊机、感应加热设备和大型电机起动器）。

放置进线电源线设备（如隔离或恒压
变压器、本地电源断路器和浪涌抑制器）远离
进线设备的正确位置使电源线按照
尽可能短，并将传输到1600的电气噪音降至低。

电源线插座必须安装在设备附近，并且应易于
可到达的
避免电源电路过载。

在固定接线中加入易于接近的断开装置
连接的系统。
确保位置不超过1600的冲击、振动和
温度规格。

Mounting Considerations This section describes issues you must address before placing the 1600 inside an enclosure. Consider the following points and precautions:
Select an enclosure and place the unit in a position that allows easy access to the 1600 ports.
Account for the unit’s depth when choosing the depth of the enclosure.
The unit must be mounted in an approved fire and electrical enclosure.
See pages 11 through 15 for mounting dimensions and instructions in this chapter.
Consider locations of accessories such as AC power outlets for installation and maintenance convenience.
Prevent condensation by installing a thermostat-controlled heater or air conditioner.
To allow for maximum cooling, avoid obstructing the airflow.
Place any fans or blowers close to the heat generating devices. If using a fan, ensure that outside air is not brought inside the enclosure unless a fabric or other reliable filter is used. This filtration prevents conductive particles or other harmful contaminants from entering the enclosure.
Do not select a location near equipment that generates excessive electromagnetic interference (EMI) or radio frequency interface (RFI) (equipment such as high power welding machines, induction heating equipment and large motor starters).
Place incoming power line devices (such as isolation or constant voltage transformers, local power disconnects, and surge suppressers) away from the 1600. The proper location of incoming line devices keeps power wire runs as short as possible and minimizes electrical noise transmitted to the 1600.
The power cord outlet must be installed near the equipment and shall be easily accessible.
Avoid overloading the supply circuit.
Incorporate a readily accessible disconnect device in the fixed wiring for permanently connected systems.
Make sure the location does not exceed the 1600’s shock, vibration, and temperature specifications.