MVI94-MCM
将示例程序下载到处理器注意：ControlLogix处理器前面的按键开关必须处于REM或PROG位置。1如果您尚未与处理器联机，请打开通讯菜单，然后选择下载。RSLogix 5000将与处理器建立通信。您不必通过处理器的串行端口下载，如下所示。您可以通过任何可用的网络连接下载。2建立通信后，RSLogix 5000将打开一个确认对话框。单击下载按钮将示例程序传输到处理器。3 RSLogix 5000将编译程序并将其传输到处理器。此过程可能需要几分钟。4下载完成后，RSLogix 5000将打开另一个确认对话框。如果按键开关处于REM位置，单击OK（确定）将处理器从PROGRAM mode（程序模式）切换到RUN mode（运行模式）。注意：如果在这些步骤中收到错误消息，请参阅RSLogix文档来解释和更正错误。

Downloading the Sample Program to the Processor Note: The key switch on the front of the ControlLogix processor must be in the REM or PROG position. 1 If you are not already online with the processor, open the Communications menu, and then choose DOWNLOAD. RSLogix 5000 will establish communication with the processor. You do not have to download through the processor's serial port, as shown here. You may download through any available network connection. 2 When communication is established, RSLogix 5000 will open a confirmation dialog box. Click the DOWNLOAD button to transfer the sample program to the processor. 3 RSLogix 5000 will compile the program and transfer it to the processor. This process may take a few minutes. 4 When the download is complete, RSLogix 5000 will open another confirmation dialog box. If the key switch is in the REM position, click OK to switch the processor from PROGRAM mode to RUN mode. Note: If you receive an error message during these steps, refer to your RSLogix documentation to interpret and correct the error.