MAC112C-0-ED-4-​C/130-A-0/W1551​/S05
电源端子排的电气连接下面的电气连接说明首先根据电源端子排的编号（例如X1、X2等）进行分组，然后根据功能进行分组。串行接口X1串行接口通常用于启动操作和维修过程中的编程、参数化和诊断。它可以作为RS 232或RS 485操作。在启动操作和维修过程中，需要RS-232接口进行编程、参数化和诊断。当通过RS-485将驱动器地址设置为操作要求时，也会使用它。使用RS 232，在使用DriveTop启动程序时，一次只能参数化一个驱动器。DKC电缆：IKS 0101 AP0224。fh5 TxD RxD GND DTR DSR RTS CTS 3 2 5 4 6 7 8 DKC 1）PC上的外部屏蔽必须连接到单元机箱。大15米1）TxD RxD GND DTR DSR RTS CTS 2 3 7 20 6 4 5 1）TxD RxD 0 V 2 1 3 6 5 4 X1电缆：IKS 0102 PC带9针D微型连接器TxD RxD 0 V 2 1 3 6 4 X1大15米PC带25针D微型连接器

Electrical connection to the supply terminal strips The description of the electrical connections below are first grouped according to numbers of the supply terminal strips (e.g. X1, X2 etc.) and then according to the functions. Serial interface X1 The serial interface is generally used for programming, parameterization and diagnoses during startup operation and service procedures. It can be alternatively operated as a RS 232 or RS 485. The RS-232 interface is needed for programming, parameterizing and diagnosis during startup operation and service procedures. It is also used when setting the drive addresses as a requirement for operations via RS-485. With the RS 232, it is possible to parameterize only one drive at a time when using the DriveTop startup program. DKC cable: IKS 0101 AP0224.fh5 TxD RxD GND DTR DSR RTS CTS 3 2 5 4 6 7 8 DKC 1) External shield on PC must be attached to unit chassis. max. 15 meters 1) TxD RxD GND DTR DSR RTS CTS 2 3 7 20 6 4 5 1) TxD RxD 0 V 2 1 3 6 5 4 X1 cable: IKS 0102 PC with 9-pin D-subminiature connector TxD RxD 0 V 2 1 3 6 5 4 X1 max. 15 meters PC with 25-pin D-subminiatureconnector