MAC090C-0-GD-4-​C/110-A-2/W1520​LX/S01
8 X9 X2 Br+Br1）1）拧紧推入式端子0.2。。。4 mm²，AWG 24-10用于保持制动器中间电路连接的电压连接（不在DKC01.1-030-3上）电源连接定位记录步进器接口控制电压控制器的选择或输入启用电机温度监控电机连接电机反馈连接15极D子接头（INS 439）模拟命令值输入扭矩减小模拟输出实际位置值（增量或SSI）零位开关定位记录确认行程限位开关Jog输入归位移动路径控制点位置准备好操作RS 485串行接口RS 232串行接口1）不在DKC11.1-040-7-FW故障清除按钮诊断指示器拧紧推入端子0.2。。。2.5 mm²，AWG 24-12驱动挡块至零点保持制动控制接地线连接和屏蔽电机电源电缆的连接

8 X9 X2 Br+ Br1) 1) Screw-down push-in terminals 0.2...4 mm², AWG 24-10 Voltage connection for holding brake Intermediate circuit connection (not on DKC01.1-030-3) Power connection Positioning record selection or inputs for stepper interface Control voltage Controller enable Motor temperature monitoring Motor connection Motor feedback connection 15-pole D-Sub connector (INS 439) Analog command value input Torque reduction Analog outputs Actual position value (incremental or SSI) Zero switch Positioning record acknowledgement Travel limit switch Jog inputs Homing in Movement in Path control point Position in Ready to operate RS 485 serial interface RS 232 serial interface 1) not on DKC11.1-040-7-FW Fault clearance button Diagnosis indicator Screw-down push-in terminals 0.2...2.5 mm², AWG 24-12 Drive stop Go to zero point Holding brake control Ground wire connection and connection for shielding the motor power cable