VMIVME-758
ezPORT设置提供了一个管理器和一个用户密码。如果同时使用两个密码，则必须首先设置主管密码。可以对系统进行配置，以便所有用户在每次系统引导时或执行ezPORT设置时，都必须使用管理员密码或用户密码输入密码。002.53（C）版权所有1985-2002，American Megatrends，Inc.要在忘记密码的情况下重置安全性，必须排空NVRAM并重新配置。清除CMOS密码：1。关闭设备电源。2、将开关S2位置1移到On。3、等待约5秒钟。4、将开关S2位置1移到Off。5、给装置通电。当重新给装置通电时，CMOS密码将被清除，CMOS将设置为其默认值。BIOS SETUP UTILITY Main Advanced PCIPnP Boot Security Chipset Exit Security Settings安装或更改密码。←→ 选择屏幕↑↓ 选择项目Enter Change F1 General Help F10 Save and Exit ESC Exit Supervisor Password：Not Installed User Password：Not Installed Change Supervisor Password Change User Password Clear User Password Boot Sector Virus Protection[禁用]

The ezPORT setup provides both a Supervisor and a User password. If you use both passwords, the Supervisor password must be set first. The system can be configured so that all users must enter a password every time the system boots or when ezPORT setup is executed, using either the Supervisor password or User password. 002.53 (C) Copyright 1985-2002, American Megatrends, Inc. To reset the security in the case of a forgotten password you must drain the NVRAM and reconfigure. To clear the CMOS password: 1. Turn off power to the unit. 2. Move switch S2 position 1 to On. 3. Wait approximately 5 seconds. 4. Move switch S2 position 1 to Off. 5. Power up the unit. When power is reapplied to the unit, the CMOS password will have been cleared, and the CMOS will be set to its defaults. BIOS SETUP UTILITY Main Advanced PCIPnP Boot Security Chipset Exit Security Settings Install or Change the password. ←→ Select Screen ↑↓ Select Item Enter Change F1 General Help F10 Save and Exit ESC Exit Supervisor Password : Not Installed User Password : Not Installed Change Supervisor Password Change User Password Clear User Password Boot Sector Virus Protection [Disabled]